Numerical study on the quench propagation in a 1.5 T MgB2 MRI magnet design with varied wire compositions

Abstract

To reduce the usage of liquid helium in MRI magnets, magnesium diboride (MgB2), a high temperature superconductor, has been considered for use in a design of conduction cooled MRI magnets. Compared to NbTi wires the normal zone propagation velocity (NZPV) in MgB2 is much slower leading to a higher temperature rise and the necessity of active quench protection. The temperature rise, resistive voltage, and NZPV during a quench in a 1.5 T main magnet design with MgB2 superconducting wire was calculated for a variety of wire compositions. The quench development was modeled using the Douglas–Gunn method to solve the 3D heat equation. It was determined that wires with higher bulk thermal conductivity and lower electrical resistivity reduced the hot-spot temperature rise near the beginning of a quench. These improvements can be accomplished by increasing the copper fraction inside the wire, using a sheath material (such as Glidcop) with a higher thermal conductivity and lower electrical resistivity, and by increasing the thermal conductivity of the wire’s insulation. The focus of this paper is on the initial stages of quench development, and does not consider the later stages of the quench or magnet protection.