Numerical study on the interface characteristics of gas–liquid falling film flow considering the interface forces

Abstract

As an energy quality improvement device, an air source heat pump plays an important role in clean heating applications. When operating in a cold and wet environment in winter, the outdoor evaporator will have the problem of frost, which affects the operation efficiency. To solve the frosting problem, the development of frost-free evaporators has attracted more and more attention. The fluctuation characteristics of the gas–liquid interface are the key factors affecting the intensity of gas–liquid heat transfer on the air side of this kind of heat exchanger. Therefore, a mathematical model is established to describe the falling film flow on the surface of the flat finned tube heat exchanger in a closed-type heat source tower. The model takes into account the interfacial tension and interphase friction force between the air flow and the liquid film. On this basis, the fluctuation intensity of the central channel interface during falling film flow with different inlet parameters is studied. It is found that there is a critical value of 1.5 m/s (i.e., Reg = 1643.0) in the air flow rate under the study conditions. When the air flow rate is higher than this velocity, the interface near the gas–liquid outlet fluctuates more frequently and the stability is poor. The distributions of interfacial velocity and pressure are also studied, and the relationship between them and interface fluctuation is analyzed. This paper aims to provide theoretical support for enhanced heat and mass transfer on the air side of finned tube heat exchangers in the closed-type heat source tower.