Abstract
To provide a feasible heat dissipation solution for a high heat flux, in this study, the internal flow and heat transfer characteristics of an externally heated concentric double tube were numerically studied via the implicit finite difference method. The outer ring and inner tube were filled with a phase change nanofluid and water, respectively. The parameter ranges were as follows: the mass fractions of the phase change material (PCM) emulsions were 2.04 %, 2.91 %, and 7.11 %, the relative flow ratio was 0.33–4.0, the heat power inputs were 70 W and 150 W, and the total tube flow rates were 304.83 cm3/min and 465.98 cm3/min. The results showed that incorporating PCM emulsions can effectively improve heat transfer performance; however, the PCM concentrations, heating conditions, and outer-annulus/inner-tube flow rates (relative flow ratios) must be properly matched so that the phase change of the working fluid occurs in the expected section. Within these parameter ranges, in the heated section, the latent heat utilization of the PCM emulsion is lower than that of the sensible heat, and only when the flow ratio is greater than 1 is the latent heat utilization of the 7.11 % PCM emulsion similar to that of the sensible heat.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
