Numerical study on effects of leading-edge manufacturing defects on cavitation performance of a full-scale propeller. I. Simulation for the model- and full-scale propellers without defect

Abstract

Paper I of this two-part paper focuses on predicting the open-water cavitation performance of the model- and full-scale propellers based on the geometry of David Taylor model basin 5168 propeller without leading-edge (LE) defect. Simulations were conducted using the three-dimensional (3D) steady Reynolds-Averaged Navier–Stokes solver in the commercial software package Star-CCM+. Effects of simulation parameters, including domain size, grid size, stretch ratio, first-grid spacing, y+, and turbulence model on the solutions were carefully examined and the best-practice settings for the model propeller and the full-scale propeller with no LE defect were developed. Validation studies were carried out for the propeller model against the experimental data. Results for the full-scale propeller were compared with those of the model-scale propeller. The differences in model and full-scale predictions are generally insignificant. To further confirm this finding, the scale effect was investigated with four additional scale ratios, λ = 2, 3, 4, and 5. The results showed that the scale effect is in general minimal and, therefore, the developed best-practice settings can be applied to the open-water simulation of the full-scale propeller. Paper II presents the simulation for the full-scale propellers with LE defects.