Numerical study on effect of design parameters of the single-circumferential groove on tip leakage flow reduction in a transonic turbine

Abstract

In order to investigate the impact of design parameters (depth, width, and location) of the single-circumferential groove (SCG) on tip leakage flow (TLF) reduction in a transonic turbine stage, a systematic investigation was conducted by high-precision numerical simulation method. The numerical results show that the introduction of SCG could improve the stage efficiency (η) of turbine significantly. The optimal design parameters of depth coefficient (ζ), width (W), and location (L) were ζ = 3, W = W3, and L = 20%Cax (where Cax denotes the axial chord of the blade), which could reduce tip clearance leakage rate (m*) by 28.9% and improve the η by 0.56%. The implementation of flow field display methods reveals that the introduction of SCG influences the formation and development of the vortex system at the rotor tip region. The circumferential groove vortex (CGV), induced by SCG, divided the tip leakage vortex (TLV) into two segments TLV_1 and TLV_2 due to its blocking effect. TLV_1 interacted with the passage vortex (PV) and depress the strength of PV. Meantime, TLV_2 would regenerate from the trailing edge of SCG, due to its limited development range and insufficient growth, the strength and scale of TLV_2 were weakened. Given that the TLF passing through SCG flows in an opposite direction to the original TLF, the SCG at appropriate location could lead to a fact that the net flow rate of the leakage flow reached the minimum value, thereby considerably reducing the m* and flow loss caused by TLF.