Numerical Study of the Effect of the Leading Edge Shape on Cavitation Around Inducer Blade Sections.

Abstract

A numerical study of the cavitation behaviour of two-dimensional hydrofoils simulating a section of an inducer blade is presented. Two leading edge shapes were chosen to approach rocket engine inducer designs. They were tested with respect to the development of sheet cavitation. The numerical model of cavitating flows is based on the 3D code FINE/TURBOTM, developed by NUMECA International. The cavitation process is taken into account by using a single fluid model, which considers the liquid vapour mixture as a homogeneous fluid whose density varies with respect to the static pressure. Numerical results are compared with experimental ones, obtained in the CREMHyG large cavitation tunnel(1). Pressure distributions along the foil suction side and the tunnel walls were measured for different cavity lengths. Total pressure measurements along the foil suction side allow characterizing the effects of cavitation on the liquid flow. Influence of the leading edge shape on the cavitation behaviour and comparison between experiments and numerical predictions are discussed.