Numerical study of film cooling effectiveness of a gas turbine blade under variable blowing ratio and turbulence intensity

Abstract

AbstractThe present paper investigates a three‐dimensional simulation of film cooling on a C3X turbine blade with a single hole at a suction surface. The Reynolds averaged Navier–Stokes approach with k–ε realizable turbulence model and enhanced wall function are used for the numerical simulation. To simulate the jet flows, the length of the jet input approximately 4.5 times the diameter of the hole is added to the geometry so that the jet outlet flow is closer to the actual condition. The density ratio of the cooling flow to the mainstream flow is assumed about 2. The numerical results in four blowing ratios of 0.5, 0.7, 1.0, and 1.4, and at the low turbulence intensity (0.02%), and high turbulence intensity (12%) are extracted and compared for the turbine blade with a single hole. The results show that the turbulence intensity has a dual effect on the film cooling effectiveness and a higher blowing ratio increases the strength of the jet against the cross‐flow. Moreover, it is illustrated that the distribution of the film cooling effectiveness in higher blowing ratios and high turbulence intensity is more uniform than the low blowing ratios and low turbulence intensity.