Numerical simulations of depressurization‐induced gas production from hydrate reservoirs at site GMGS3‐W19 with different free gas saturations in the northern South China Sea

Abstract

AbstractClass 1 hydrate reservoirs are regarded as the most promising targets for gas production. Previous investigations in the northern South China Sea have proven that the low‐permeability hydrate reservoir at site GMGS3‐W19 is a Class 1 hydrate deposit. However, the dynamic production behaviors of this type of reservoir are not yet fully understood. Here, we report gas recovery from hydrate reservoirs containing underlying free gas layers with different initial gas saturations and investigate the effects of absolute permeability and depressurization pressure on gas production performance. The results show that high initial gas saturation of the underlying free gas layer and low bottom‐hole pressure are advantageous for enhancing the gas production performance. The effects of absolute anisotropic permeability and isotropic permeability on gas recovery from Class 1 hydrate reservoirs are different. For long‐term gas production from this hydrate reservoir with any initial gas saturation, a higher horizontal permeability (permeability anisotropy more than 10) in the hydrate layer is remarkably beneficial to stimulate gas extraction and decrease the amount of produced water replenished by inflows from permeable overlying and underlying sediments. Moreover, the gas production rate is highly consistent with the hydrate dissociation ratio, one of the main factors affecting the gas production performance, in Class 1 hydrate reservoirs with different permeabilities. However, for this type of hydrate reservoir with permeability anisotropy larger than 5, the larger the horizontal permeability in the hydrate layer can form more secondary hydrates. The increment in secondary hydrate formation negatively influences the hydrate dissociation ratio and gas recovery. Thus, it is also significant to weigh the permeability anisotropy of the hydrate layer and the secondary hydrate formation amount during the production progress. These findings can contribute to estimating the gas recovery efficiency in Class 1 hydrate reservoirs and optimizing the production process in similar areas.