Numerical simulation of unsaturated flow in woven fiber preforms during the resin transfer molding process

Abstract

AbstractIn this paper, the unsaturated flow encountered in the woven or stitched fiber mats used in RTM is simulated using an adaptation of the Finite Element Method/Control Volume (FEM/CV) technique. The movement of resin through such fiber mats is modeled as flow through dual scale porous media and the mass balance in such media creates a sink term in the equation of continuity of the macroscopic flows. Combining this equation with Darcy's law leads to a non‐homogeneous non‐linear elliptic partial differential equation for pressure that is solved iteratively. First the simulation is used to study simple flows encountered during the characterization of preforms, such as the constant injection pressure 1‐D flow and the constant flow rate radial injection flow. Previously observed experimental results of relatively flatter pressure histories for the latter type of flows in wove fiber mats are replicated, both numerically and analytically, by the pressure equation with the sink term. A quantity called pore volume ratio is shown to play an important role in such flows. Finally, the unsaturated flow in a typical RTM mold, packed with woven fiber mats, is simulated numerically, and inlet pressures, fill times, and mat saturation are studied.