Numerical simulation of underground excavations in an indurated clay using non-local regularisation. Part 1: formulation and base case

Abstract

The paper presents the numerical simulation of an underground excavation in the Callovo-Oxfordian argillaceous formation, performed in the Meuse/Haute-Marne underground research laboratory, within the context of deep geological nuclear waste disposal. The constitutive model adopted incorporates a number of characteristic features of the hydromechanical behaviour of the Callovo-Oxfordian claystone, and other indurated clays, including anisotropy and time-dependent deformations. Model parameters have been largely determined from available experimental results. Particular attention has been given to the incorporation of a non-local formulation in order to simulate localised deformations objectively. It is shown that the numerical analysis is able to provide a very satisfactory reproduction of the extent and configuration of the excavation-induced fractured zone, the development of rock displacements and the evolution of water pressures in the rock. The analysis is also able to provide a deeper insight into the mechanisms underlying the generation of water pressures inside the rock mass.