Numerical simulation of three-phase flow in an external gear pump using immersed boundary approach

Abstract

• Modelling the compressibility of gas is critical for predicting its effects on cavitation . • Effect of increased gas (NCG) content in the fluid is to decrease the cavitation. • More flow fluctuations are observed at the outlet with higher NCG content. • Modelling contact between the gears is critical for accurate cavitation prediction. • Higher gear RPM results in higher rate of cavitation. This paper presents a three-phase fully compressible model applied along with an immersed boundary model for predicting cavitation occurring in a two dimensional gear pump in the presence of non-condensable gas (NCG). Combination of these models is capable of overcoming numerical challenges such as modelling the contact between the gears and simulating the effect of NCG in cavitation. The model accounting for the effect of NCG also has broader applicability, since gas dissolved in liquids can come out of the solution when exposed to low pressures; this plays a significant role in the pump performance and cavitation erosion . Here the simulation results are presented for the gear pump at different operating conditions including the contact between gear, gear RPM and % of NCG; their effects on performance and cavitation is demonstrated. The results suggest that modelling the contact between the gears play a role in the cavitation prediction inside the gear pump. An increase in cavitation is observed when the contact is modelled even for the small pressure difference considered between the inlet and outlet. An increase in the RPM of the gears also results in increased cavitation within the pump, whereas an increase in the percentage of NCG content by a small amount can reduce the cavitation to a greater extent. This reduction is due to the expansion of the gas at a lower pressure which recovers the pressure and prevents or delays the phase-change process of the working fluid. The fluctuations in the outflow rate is also found to increase when the gears are in contact and also with increasing gas content.