Abstract
The efficiency and heat utilization of modern large‐scale blast furnace in China are close to limits. The potential for energy saving and consumption reduction by continuing to improve blast furnace operation is limited, so there is a need to develop nonblast furnace ironmaking technologies to solve the problems of high energy consumption and pollution. The emerging flash ironmaking technology, which is highly efficient and has low pollutant emissions, has become an option. This article uses CFD software to simulate the 3D steady‐state hydrogen‐based flash ironmaking process at a pilot scale. It is a complex system involving gas‐particle two‐phase flow, heat transfer, and chemical reactions. The article mainly studies the effects of the feeding mode and hydrogen concentration in the reducing gas on the reduction of ore particles. The results show that the residence time of the particles in the furnace is very sensitive to the feeding method, and the maximum residence time of the particles reaches about 2.8 s under the optimal feeding method. In addition, increasing the hydrogen concentration in the reducing gas decreases the particles’ residence time. However, the minimum residence time is more than 2.2 s, and the ore powder can still obtain a high reduction degree.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
