Abstract
Springback is a problem that must be solved in multi-point forming in this paper, finite element software ls-dyna was used to simulate plate stamping springback. 3mm thick elastic cushion inhibited dimple of sheet forming, but the use of elastic cushion and plate springback would lead to shape error. A method was proposed which modified the forming surface of element group in the Multi-point forming (MPF) by iterative ways according to the numerical simulation results. The accuracy of forming was improved after two compensation, it was proved that this method can compensate springback of the multi-point forming.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.