Abstract
This paper describes the peculiarities encountered in the numerical modeling of non-circular spinning processes using motion-controlled roller tools and applying the Finite Element Method (FEM). This process is suitable for producing non-circular, hollow components in small to medium-sized production lots. Numerical simulation can be used to optimize the process. Therefore, it is necessary to make a realistic sheet thinning and wrinkling calculation by using the FEM. This can be achieved through the definition of the real kinematics, a suitable flow curve and an optimal sheet meshing strategy using solid elements. An optimal sheet meshing strategy is particularly necessary in order to realistically calculate the process within an acceptable computing time. Reference experiments with the rotationally non-symmetric mandrel types, the “Tripode” and “Pagoda”, were carried out to compare simulations and experiments. A comparison of the reference experiments with the “Tripode” mandrel demonstrated that it is possible to simulate non-circular spinning with a deviation of less than 5% with respect to minimum sheet thickness. It is also possible to predict wrinkling in critical, non-circular spinning processes. This has been confirmed by comparing the “Pagoda” reference experiment with the FEM simulation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.