Abstract
A three-layers assembled cavity die and its technological measures were designed for cold extrusion forming for the bevel gear. Numerical simulation of the cold extrusion forming process was applied using Deform-3D software, load curve, velocity field, stress field and temperature field were analyzed, thus obtain the basic knowledge of the law of the bevel gear deformation. Subsequent targets for optimization were introduced, aiming to solve the remaining problems of the current cold extrusion forming. The accomplished work shows some significance in guiding how to design a die and its technological measures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
