Abstract

Molten metal atomization in close-coupled gas atomization dies can operate between two limiting conditions, jetting and filming, together with several complex mechanisms: liquid-gas drafting, downward/upward shearing, melt bouncing, etc. Liquid jet deformation depends on flow and geometric parameters, such as liquid Reynolds, liquid Weber, and gas Mach numbers, as well as gas jet apex angle and melt tube tip extension and aspect ratio, among others. Understanding their effect is of importance for the metal powder making industry. Numerical gas atomization studies can provide approximated flow information and consider a wide range of conditions, beyond experimental reach. Here, 3D high-resolution simulations employing a 5-equation compressible flow model coupled with the volume-of-fluid method are compared with experiments, for liquid Weber number in the range of 1–30 and liquid Reynolds number below 10,000. This validation explores the predicting capabilities of the numerical model.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.