Numerical simulation and investigation of ultra-short pulse laser ablation on Ti6Al4V and stainless steel

Abstract

In ultra-short pulse laser machining and micro/surface processing, accurate simulation of laser ablation is important for understanding laser-target interaction and improving ablation performance, but it remains challenging. This work aims to develop a numerical model to improve the accuracy of the ablation depth calculation. A grid deformation scheme is proposed based on energy conservation and considering contributions to instant material removal from both the electron and lattice subsystems. By incorporating this scheme with the two-temperature model (TTM), a reasonable prediction of the instant target surface profile during laser ablation has been achieved. In the case of single-pulse femtosecond laser ablation of Ti6Al4V, the calculated ablation depth ranges from 0.06 to 0.56 μm for laser energy from 1.0 to 10.0 μJ. For single-pulse picosecond laser ablation of stainless steel, as laser energy increases from 6.0 to 18.5 μJ, the predicted ablation crater deepens accordingly from 40 to 87 nm. In addition, for multi-pulse picosecond laser ablation of stainless steel, a linear dependence of the ablation depth on the pulse number is observed up to a depth of about 803 nm at 6.0 μJ and 20 pulses. In all the above-mentioned cases, the calculation results are in better agreement with experimental measurements than conventional TTM or other material removal schemes, validating the accuracy of the proposed model.