Abstract
In the oxygen-enriched side-blown smelting furnace for the treatment of electroplating sludge, fluent was used to simulate the gas–liquid two-phase flow process. The relationship between the lance diameter, lance inclination, bath depth, and the bath evaluation indicators were studied, and the oxygen lance spacing was optimized. The results show that the high velocity and high gas rate areas were near the oxygen lance, while the stirring dead zones with low velocity appeared in the central and bottom areas of the molten pool. The key parameters were optimized using single-factor analysis and multifactor comprehensive optimization. The results showed that the bath evaluation indicators were all at good levels under the optimal parameter conditions. These were comprehensively obtained as the following: the lance diameter was 25 mm, the lance inclination was 15°, the lance spacing was 1050 mm, and the bath depth was 1500 mm. The industrial test carried out in an environmental protection enterprise in Guangdong achieved satisfactory results. The test shows that the electroplating sludge containing 7.24% Cu can be melted at 1300~1400 °C to obtain matte. Compared with industrial copper slag, the smelting slag has a higher CaO and a lower Fe content.
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
