Abstract
Falling film evaporation technology is widely used in the treatment of salt-containing wastewater in coal chemical industry. However, there is still a lack of research on the inlet method of vertical falling film evaporation tubes. In this paper, the heat and mass transfer processes of saline wastewater under vertical and tangential inlets were investigated using numerical simulations. On this basis, the differences in flow and heat transfer processes between saline wastewater and pure water under tangential inlet were investigated. The results showed that the flow velocity of saline wastewater with a falling film evaporation tube in a tangential inlet mode was larger. Meanwhile, the turbulence in this way was more intense and the fluid temperature in the vertical tube was higher. Saline wastewater has higher temperature and smaller liquid volume fraction than pure water liquid membrane in the range of 193-1,000 mm from the inlet. The use of tangential inlet method to treat salt-containing wastewater has higher evaporation efficiency and is a very effective way to guide the improvement of heat transfer efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Water science and technology : a journal of the International Association on Water Pollution Research
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
