Numerical Process and Plant Simulation Methods

Abstract

AbstractThis paper represents an attempt to explicitly map the conceptual activities which constitute a process design task into a series of well‐posed, complete and general numerical procedures. In spite of the fact that there is substantial number of design manuals and design procedures which process engineers can consult to choose the most proper approach to a particular problem, there is a remarkable lack of generality on the one side (procedures which apply to the design of a wastewater treatment process cannot be used even in principle to design a fluidized bed system), and an obvious receptivity on the other side (all procedures involve mass and energy balances at some point). With the advance of numerical techniques, virtually every procedure has been computerized, so that engineers can avail themselves of a multitude of computer tools in the majority of their process design activities: as a result of the lack of coordination among different producers though, the situation for what codes are concerned is very confusing: there are many codes which perform nominally the same task, giving (sometimes substantially!) different results when applied to the very same problem; each code sue its won set of property tables, its own I/O format, etc. Finally, with very few exceptions, these codes are not mutually compatible, i.e. the output from any of them cannot be used as the input to any of the other, not only because of the respective formats, but rather because the quantities taken to represent a certain physical process are not the same in different codes.This is a very unsatisfactory state of affairs, both for the final user and for the software producer. Unfortunately, this seems to be a problem for which commercial, technical and historical reasons make it very difficult to find a solution in the short term. The author is convinced that an early exposure to this problem and to a new approach to its solution can only benefit our engineering students, and has therefore endeavored, together with his coworkers, to devise a “modular approach” to the solution of process simulation problems. The material presented here has been originated by a series of lectures and seminars developed in the last three years for master and doctoral level students in Mechanical Engineering. The result of this “distillation” process maybe yet unripe, as they are definitely not complete: but the implications, also in terms of practical application, are very promising, and the approach deserves more attention in the future.The order of presentation of the material is historical/logical: it beings with the old fashioned slide‐rule calculations and proceeds towards the most recent developments of AI base methods. The path is made clear from the very beginning: we are trying to extract from the various engineering activities all the essential knowledge which pertains to the engineer himself, with the final goal of transferring this body of knowledge ‐ in some form suitable to machine communication ‐ to a “universal‐process simulator”, which can then be applied with a high degree of confidence to variety of particular process simulations.