Numerical modelling of CO2-in-water emulsion injection into a water-saturated core

Abstract

Depressurization method shows promise for methane hydrate (MH) reservoir production, but the reformation of hydrates due to a lack of geothermal heat presents a significant challenge for commercial production. This study proposes a novel approach for MH gas recovery by injecting a CO2-in-water (C/W) emulsion into an MH reservoir aquifer. The exothermic nature of CO2 hydrate formation and liquid CO2 dissolution in water in this method provides heat to the MH layer, effectively preventing hydrate reformation. Subsequently, 1-D numerical models were developed and implemented using the MATLAB Reservoir Simulation Toolbox (MRST). These models were rigorously validated against experimental data under homogeneous conditions and varying injection schemes. The investigation indicated that the average volume fraction of CO2 hydrate within the hydrate particles was found to be 55% of the volume of liquid CO2 droplets. The alternating C/W emulsion injection increased the driving force for CO2 dissolution in water, thereby promoting subsequent hydrate particle decomposition and CO2 hydrate dissolution in water, which effectively mitigated blockage within the porous medium. In conclusion, water alternating C/W emulsion injection, along with the continuous injection of a low volume fraction of liquid CO2 within the C/W emulsion, exhibits promising potential for sustained injection and provides adequate heat to the MH layer, preventing hydrate reformation. Furthermore, the developed numerical model reasonably predicts the behavior of various injection schemes. This developed model can be used for devising long term sub-seabed carbon capture and storage development plan.