Abstract
The molten-salt heat exchanger is a critical heat transfer device used in concentrated solar power systems. In this paper, molten salt heat-transfer performance characteristics and flow resistances in shell and tube heat exchangers with perforated baffles with a notch height of 0.25D (D is the baffle diameter) are simulated. Four opening schemes that use the same opening area (10% of the baffle area) are designed. The numerical results show that the baffle holes can shrink the molten salt flow dead zone significantly and greatly decrease the flow resistance on the shell side at the cost of a slight reduction in the heat-transfer performance. The comprehensive performance of each scheme after opening is higher than that before opening, and the comprehensive performance of Scheme 4 is the best. Next, a genetic algorithm is used to optimize the Scheme 4 opening diameter. The results show that the heat-flux density on the molten-salt side reaches a maximum of 17327 W/m2 when the opening diameter is 2.24 mm. We find that the opening diameter should be maximized to optimize the comprehensive performance at a given pump power. Finally, the data are compared to other correlations. The deviation decreases gradually as the Reynolds number increases. This is because the turbulence enhancement caused by structural change is not substantial at high Reynolds numbers.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
