Abstract
AbstractDuring the vacuum‐assisted resin transfer molding (VARTM) processing, the post‐infusion behavior after complete wet‐out and before gelation of the resin is critical for the development of the thickness and fiber volume fraction distribution in the cured composite part. The pressure gradient developed during infusion results in a thickness gradient due to the flexible nature of the bagging approach. After full infusion, the resin typically bleeds into a vacuum trap, allowing redistribution of pressure and preform thickness. In this study, a non‐rigid control volume is used to formulate a set of governing equations for analysis of the post‐infusion process. The model is used to investigate the effects of processing parameters and different processing scenarios on resin flow, resin pressure, and thickness variation of the composite laminate. This work provides a tool for optimization of the VARTM process to reduce final part variability. POLYM. COMPOS., 2009. © 2008 Society of Plastics Engineers
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
