Abstract
Turbomachinery design is associated with a comprehensive understanding of the end wall loss mechanism which is more complicated when the rim seal purge flow is taken into consideration. Ensuring an adequate life of high pressure turbine requires efficient cooling method to keep the disk temperature at an acceptable level. Hence, purge flow is injected through the rim seal in axial turbine in order to prevent hot gas ingestion into the rotor disk. This paper focused on the effect of upstream rim seal purge flow on turbine aerodynamic design parameters in a low aspect ratio axial turbine. Besides, end wall secondary flows and interaction between the rim seal purge flow and mainstream were also highlighted. Two different rim seal configurations were taken into account, i.e., inclined axial rim seal configuration and radial rim seal configuration. The purge flow rate approximately equaled to 1% of main flow which is the typical value in modern aero-engine secondary air system. Results show that inclined axial rim seal configuration is obviously superior to the radial one in terms of aerodynamic and sealing performance. The turbine aerodynamic design parameters and end wall flows are significantly modified by the purge flow. The change of pressure field and vortex structure near the hub region directly leads to the variation of turbine aerodynamic design parameters. In addition, the pressure leg of horse shoe vortex nearly disappears and cavity induced vortex appear when the flow is injected from rim seal. Moreover, the two legs of cavity induced vortex have the same rotating direction which form the passage vortex and propagate downstream in the main passage. Current research demonstrates that it is important to consider the effect of rim seal purge flow in turbine aerodynamic design and end wall profile optimization.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.