Numerical investigation of mixing process of high-pressure jet-cutting clay by water–air coaxial nozzle considering soil rheological properties

Abstract

Simulation and accurate modeling of the mixing process of the high-pressure jet-cutting clay by the water–air coaxial nozzle is significantly important for the performance optimization of the triple fluid jet grouting. In this paper, a numerical model considering the soil rheological properties is proposed to investigate the mixing process of the high-pressure jet-cutting clay. The cohesive force model of clay is obtained based on the solution of the power law index and consistency factor by coupling the Herschel-Bulkley and soil logarithmic models. The interaction model among the gas phase, the liquid phase, and the clay medium is further established through use of the drag force model. A laboratory device of high-pressure jet-cutting transparent clay is developed to prove the feasibility of the proposed model for the mixing process of the high-pressure jet-cutting clay. Finally, using the validated numerical model, the mixing process of the high-pressure jet-cutting clay by the water–air coaxial nozzle with varying radial spacings between the air nozzle and water nozzle is numerically investigated, and the axial stability of the jet, the width of the cross-sectional profile, and the variation of the central axis velocity field of the mixing process are analyzed. Results demonstrated that the variation trend of the jet in both simulations and experiments is consistent, and the maximum error in jet depth is better than 3.3%, validating the accuracy of the numerical model of the mixing process of the high-pressure jet-cutting clay. The optimal radial spacing size for a water–air coaxial nozzle in high-pressure jetting of clay medium is 1.4 mm, which provides the best axial stability, the narrower jet cross-section, and the slowest decay of jet velocity along the central axis.