Numerical investigation of intra-abdominal pressure and spinal load-sharing upon the application of an abdominal belt

Abstract

Chronic low back pain patients may experience spinal instability. Abdominal belts (ABs) have been shown to improve spine stability, trunk stiffness, and resiliency to spinal perturbations. However, research on the contributing mechanisms is inconclusive. ABs may increase intra-abdominal pressure (IAP) and reduce paraspinal soft tissue contribution to spine stability without increasing spinal compressive loads. A finite element model (FEM) of the spine inclusive of the T1-S1 vertebrae, intervertebral discs (IVDs), ribcage, pelvis, soft tissues, and abdominal cavity, without active muscle forces was developed. An identical FEM with an AB was developed. Both FEMs underwent trunk flexion. Following validation, the models’ intervertebral rotation (IVR), IAP, IVD pressure, and tensile stress in the multifidus (MF), erector spinae (ES), and thoracolumbar fascia (TLF) were compared. The inclusion of an AB resulted in a 3.8 kPa IAP increase, but a decreased average soft tissue tensile stress of 0.28 kPa. The TLF withstood the majority of tension being transferred across the paraspinal soft tissues (>70 %). The average IVR in the AB model decreased by 10 %, with the lumbar spine experiencing the largest reduction. The lumbar IVDs of the AB model likewise showed a 31 % reduction in average IVD pressure. Using an AB improved trunk bending stiffness, primarily in the lumbar spine. Wearing an AB had minimal effect on reducing tensile stress in theES. The skewed stress distribution towards the TLF suggests its large contribution to spine stability and the potential advantage in unloading the structure when wearing an AB, measured herein at8 %.