Abstract

Numerical investigation of heat transfer and fluid flow in a single pass counter flow chevron corrugated-plates plate heat exchanger considering nanofluids (CeO2 and Al2O3) as homogeneous mixtures has been presented in this paper using the Commercial CFD software, ANSYS FLUENT. The required thermophysical properties of the nanofluid were measured and used in the CFD model through UDF (User Defined Function) commercial CFD software ANSYS/FLUENT. Individual optimum concentration of CeO2/water and Al2O3/water nanofluids yield maximum heat transfer improvement has experimentally determined and then CFD simulation has been done with those concentrations to obtain the temperature, pressure, and velocity fields. The results of numerical simulation were compared with experimental data in order to verify the accuracy of the homogeneous model. Validation of the CFD model suggests that considering nanofluid a homogeneous mixture, simulation can be performed to predict the plate heat exchanger performance with reasonable accuracy. CFD simulation shows that corrugation pattern of the plate develops turbulence and vortices of fluid which results in high heat transfer rates.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.