Numerical Investigation of Gravitational Compositional Grading in Hydrocarbon Reservoirs Using Centrifuge Data

Abstract

Summary Fluid properties descriptions are required for the design and implementation of petroleum production processes. Increasing numbers of deep water and subsea production systems and high-temperature/high-pressure (HTHP) reservoir fluids have elevated the importance of fluid properties in which well-count and initial rate estimates are quite crucial for development decisions. Similar to rock properties, fluid properties can vary significantly both aerially and vertically even within well-connected reservoirs. In this paper, we have studied the effects of gravitational fluid segregation using experimental data available for five live-oil and condensate systems (at pressures between 6,000 and 9,000 psi and temperatures from 68 to 200°F) considering the impact of fluid composition and phase behavior. Under isothermal conditions and in the absence of recharge, gravitational segregation will dominate. However, gravitational effects are not always significant for practical purposes. Since the predictive modeling of gravitational grading is sensitive to characterization methodology (i.e., how component properties are assigned and adjusted to match the available data and component grouping) for some reservoir-fluid systems, experimental data from a specially designed centrifuge system and analysis of such data are essential for calibration and quantification of these forces. Generally, we expect a higher degree of gravitational grading for volatile and/or near-saturated reservoir-fluid systems. Numerical studies were performed using a calibrated equation-of-state (EOS) description on the basis of fluid samples taken at selected points from each reservoir. Comparisons of measured data and calibrated model show that the EOS model qualitatively and, in many cases, quantitatively described the observed equilibrium fluid grading behavior of the fluids tested. First, equipment was calibrated using synthetic fluid systems as shown in Ratulowski et al. (2003). Then real reservoir fluids were used ranging from black oils to condensates [properties ranging from 27° API and 1,000 scf/stb gas/oil ratio (GOR) to 57°API and 27,000 scf/stb GOR]. Diagnostic plots on the basis of bulk fluid properties for reservoir fluid equilibrium grading tendencies have been constructed on the basis of interpreted results, and sensitivities to model parameters estimated. The use of centrifuge data was investigated as an additional fluid characterization tool (in addition to composition and bulk phase behavior properties) to construct more realistic reservoir fluid models for graded reservoirs (or reservoirs with high grading potential) have also been investigated.