Abstract
In this work, the effect of rock bolt angle on the shear behavior of Rock Bridges is investigated using the particle flow code in two dimensions (PFC2D) for three different Rock Bridge lengths. Firstly, the calibration of PF2D is performed to reproduce the gypsum sample. Then the numerical models with the dimensions of 100 mm * 100 mm are prepared. The Rock Bridge is created in the middle of the model by removal of the narrow bands of discs from it. The uniaxial compressive strength of the Rock Bridge is 7.4 MPa. The Rock Bridge lengths are 30 mm, 50 mm, and 70 mm. The rock bolt is calibrated by a parallel bond. The tensile strength of the simulated rock bolt is 360 MPa.One rock bolt is implemented in the Rock Bridge. The rock bolt angles related to the horizontal axis are the changes from 0 to 75 degrees. Totally, 18 models are prepared. The shear test condition is added to the models. The normal stress is fixed at 2 MPa, and the shear load is added to the model till failure occurs. The results obtained show that in a fixed rock bolt angle, the tensile crack initiates from the joint tip and propagates parallel to the shear loading axis till coalescence to rock bolt. In a constant Rock Bridge length, the shear strength decreases with increase in the rock bolt angle. The highest shear strength occurs when the rock bolt angle is 0°.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.