Numerical investigation and optimization of the melting performance of latent heat thermal energy storage unit strengthened by graded metal foam and mechanical rotation

Abstract

In this paper, a combined passive graded metal foam and active mechanical rotation strategy is proposed to simultaneously solve the problem of slow melting rate and non-uniform phase change problem of the latent heat thermal energy storage (LHTES) technology. The enthalpy-porosity method and fixed grid structure are employed to numerically investigate the effects of porosity range, the number of graded layers, and the rotational angular velocity. Moreover, the response surface method (RSM) is further selected to optimize the structural parameters and obtain the function of melting performance and various factors. The result shows that there is an optimal porosity range and the total melting time decreases first and then increases with the increase of porosity range. When the porosity range is 12 % and the graded layer is three, it can shorten the melting time by 35.54 % and increase the thermal energy storage rate (TESR) by 51.57 %. In addition, the melting performance is gradually improved as the number of graded layers increases. The strengthening effect of graded metal foam with just four layers is close to that of the maximum layers considered in this paper. The trend of the influence of rotation speed on the melting performance of the LHTES unit is consistent with the porosity range, indicating the existence of the optimal rotational speed. The RSM optimization structure, with a 14.969 % porosity range, 5-layer graded number, and 2.267 rpm rotational speed, shortens the melting time by 42.42 % and increases the TESR by 62.75 % compared with the stationary case with uniform metal foam. This work verifies the effectiveness of active rotation coupling with passive graded porous structures, which could provide a new strengthening approach to enhance LHTES.