Abstract
One of the several key subsystems in the test facility of Korean sodium-cooled fast reactor is a plugging meter system, which measures the impurities in the sodium using an indirect online technique. To measure the low flow rate, a permanent magnet flowmeter was developed owing to its inherent fast response time, non-invasive characteristic, relatively accurate flow rate measurements, and excellent linearity between the flow rate and flowmeter signal. However, several limitations have been reported in the experimental evaluation of the flowmeter under low flow rate conditions given the measurement capability of the current experimental facility. Thus, the performance of the flowmeter was evaluated numerically using a commercial computational fluid dynamics tool, a FLUENT/MHD module, based on the finite volume method with the help of electromagnetic analysis software, ANSYS MAXWELL. The FLUENT/MHD module was validated by comparing the simulation results with the experimental results. The relative error of the FLUENT simulation was estimated to be approximately 0.24% compared with the experimental results. After the validation process, MHD simulations were conducted to calculate the flowmeter voltage signals versus flow rates, especially in a low flow rate regime, where the linearity between the flow rate and flowmeter signal was carefully analyzed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
