Numerical design for cathodic protection systems for concrete

Abstract

AbstractCathodic protection (CP) has become a successful method for the rehabilitation of concrete structures affected by chloride‐induced corrosion of reinforcing steel. CP involves applying an electrical current from an external anode through the concrete to the reinforcement. The current causes steel polarisation, electrochemical reactions and ion transport. Normally the anode is placed over relatively large surface areas, including those where the steel is passive. Conventional views assume that protection current will not significantly flow outside the anode area. In many cases this results in a conservative design. This paper presents principles and first results of numerical calculations for design of an example CP system by finite element modelling. The final objective is to develop a tool for more economical CP system design. In particular, a CP system for the protection of local damage in bridges (e.g. at leaking joints) has been simulated. The corroding area with respect to the size of the anode is varied. Current and potential distributions and depolarisation values are predicted, both close to and more distant from the anode. It appears that current densities required to achieve sufficient polarisation are much higher than those usually found in the field. Neglecting time‐dependent repassivation processes is likely to be the main cause and further work is needed to include them. The present model can be used with reasonable confidence for preventive application to passive steel.