Abstract
The characterisation of frictional phenomena at the tool–chip–workpiece interface in metal cutting remains a challenge. This paper aims at identifying a workpiece surface temperature and an equivalent plastic strain at this interface during the dry cutting of an AISI 1045 with TiN–coated carbide tools. A 3D arbitrary Lagrangian Eulerian (ALE) numerical model simulating the frictional test has been developed to extract local parameters around the spherical pin, such as the plastic strain and the workpiece surface temperature, from experimental macroscopic measurements. A large range of sliding velocities (5–300/min) has been investigated. It has been shown that plastic strain and workpiece surface temperature are mainly dependent on sliding velocity. Two friction regimes have been identified. These numerical results provide a better understanding of the tribological phenomena along the tool–chip–workpiece interfaces in dry machining of an AISI 1045 steel with a TiN–coated carbide tool.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Microstructure and Materials Properties
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.