Numerical and experimental studies of water disinfection in UV reactors.

Abstract

Performance of UV reactors for water disinfection is investigated in this paper. Both experimental and numerical studies are performed on base reactor LP24. Enterobacteria phage MS2 is chosen as the challenge microorganism in the experiments. Experiments are conducted to evaluate the effect of different parameters, i.e. flow rate and UV transmission, on the reactor performance. Simulation is carried out based on the commercial software ANSYS FLUENT with user defined functions (UDFs) implemented. The UDF is programmed to calculate UV dose absorbed by different microorganisms along their flow trajectories. The effect with boundary layer mesh and without boundary layer mesh for LP24 is studied. The results show that the inclusion of boundary layer mesh does not have much effect on the reactor performance in terms of reduction equivalent dose (RED). The numerical results agree well with the experimental measurements, hence validating the numerical model. With this achieved, the numerical model is applied to study other scaled reactors: LP12, LP40, LP60 and LP80. Comparisons show that LP40 has the highest RED and log inactivation among all the reactors while LP80 has the lowest RED and log inactivation.