Abstract
The heat transfer behavior during wire arc additive manufacturing is closely related to the dimensional accuracy and performance of the formed part. To investigate the thermal behavior of stainless steel 316L straight wall part fabricated by the wire arc additive manufacturing process, a three-dimensional transient finite element model is established based on the double elliptic heat source model. At the same time, the temperature measurement experiment on the characteristic position of the substrate is carried out. The thermal cycle curve obtained by the finite element model is in good agreement with the measured result. By analyzing the simulation results, the finite element model established can effectively reveal the thermal behaviors such as melting, solidification, heat accumulation and remelting during the forming process of the straight wall part. In addition, the solidification parameters obtained by the model are correlated with the microstructure. High G/R induces the production of cellular crystals and columnar dendrites, on the contrary, the formation of equiaxial crystals, which provide guidance for the prediction of the morphology of the microstructure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
