Numerical and experimental investigation of impact on bilayer aluminum-rubber composite plate

Abstract

Abstract This paper aims to investigate the performance of an aluminum–rubber composite plate under impact loading. The impact resistance of the plate has been evaluated using both experimental and numerical methods. The experimental tests were carried out using gas gun at velocities of 75, 101, 144 and 168 m/s. The energy absorption of composite plates has been closely examined for all samples. The effect of rubber layer positioning either on front face or on back face of the aluminum plate was also evaluated. It was found that the composite plate with rubber on front face provides higher performance to absorb the energy. In parallel to the experiment, a finite element model was created using the finite element software LS-DYNA to simulate the response of the aluminum–rubber composite plate under a high energy rate loading condition. The data obtained from finite element modeling shown a close agreement with the experimental results in terms of failure mechanism and energy absorption. In addition, a parametric study was carried out incorporating different impact velocities, rubber formulation, rubber layer thickness, interface bonding strength between rubber and aluminum layers and ballistic performance of aluminum-rubber sandwich panel. It was concluded that by increasing the rubber layer's thickness the energy absorption of the composite plate will be increased, especially when rubber layer placed in front face of the aluminum plate. Although at high interface bonding of rubber and aluminum layer, the composite with rubber layer in front face has better performance, but low bonding of interface lead to higher energy absorption in back face configuration.