Abstract
AbstractIn this study two‐dimensional finite element model of Al/SiC metal matrix composites (MMC) are investigated by the use of ABAQUS/Explicit software. Chip formations and machining forces during machining of MMC have been studied and compared to experimental data. It was found that the resulted chips in simulation and the generated chips in experiments both have saw‐tooth in appearance. On the other hand, the obtained cutting forces diagrams from simulation and experimental conditions have considerable fluctuating with passing cutting time. This is due to the interaction between tool and SiC particles during chip formation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
