Numerical and Experiment Studies of Different Path Planning Methods on Mechanical Properties of Composite Components.

Abstract

The purpose of this paper is to study the effects of different trajectory planning methods on the mechanical properties of components. The scope of the research includes finite element simulation calculation and experimental tests of the actual structure. The test shall be carried out in the whole load range until the failure of the structure occurs. Taking the composite conical shell as an example, a variable angle initial path generation method of the conical shell surface is proposed, and the parallel offset algorithms based on partition and the circumferential averaging are proposed to fill the surface. Then, finite element analysis is carried out for the paths that satisfy the manufacturability requirements, the analysis results show that the maximum deformation and maximum transverse as well as longitudinal stress of fiber of circumferential averaging variable angle path conical shell are reduced by 16.3%, 5.85%, and 19.76%, respectively, of that of the partition variable angle path. Finally, the strength analysis of conical shells manufactured by different trajectory design schemes is carried out through finite element analysis and actual failure tests. The finite element analysis results are in good agreement with the experimental results of the actual structure. The results show that the circumferential uniform variable angle has good quality, and it is proved that the path planning algorithm that coordinates path planning and defect suppression plays an important role in optimizing placement trajectory and improving mechanical properties of parts.