Abstract
Problem statement: The importance of diesel particulate filter has been increased later because of its ability in making emission reduction of the exhaust gasses. Diesel Particulate Filters (DPF) do two important jobs: gas emissions reduction and noise reduction, the pores spread inside the DPF store some gases and soot emissions and on the other side it prevents some sound or noise to be gone outside, so it works as a noise reduction device or unit. Diesel particulate filter is considered as a porous media, it's very important to study the flow behavior in such media in order to redesign dimensions, specifications and location of diesel particulate filter on the exhaust pipes. Approach: The flow of gasses through the Diesel Particulate Filters (DPF) unit is studied here analytically and numerically to reach for the best equation describes the real nature of flow behavior. The analytical model is built to find the velocity of flow, pressure drop and nature of flow-laminar or turbulent- at two conditions at cold conditions (25˚C) and hot conditions (500˚C). Also the problem is solved numerically using some appropriate software. A comparison was made between both analytical and numerical results especially the pressure drop effect. Some appropriate software used to describe the reality of the gasses flow through porous media. Results: It was found that the nature gases flow in DPF is laminar; a pressure drop through the DPF was occurred, gases axial velocity, vertical velocity, temperature are all decrease as such gases go through the filter. Vertical velocity's values were very small compared with the axial velocity's values. Conclusion/Recommendations: Gases pressure is decreased as such gases flow along the DPF unit and exhaust system, so there is a pressure drop. Temperature distribution and profiles showed that the values of temperature have a fluctuation along the DPF unit. Axial and vertical velocities were decreasing as the gases flow through the DPF unit and the exhaust system. It is recommended to study the flow as a non-linear 3D problem.
Highlights
The flow in the pure fluid region is usually described by the Navier-Stokes system of equations
The results describe in addition the pressure distribution, wall shear and contours and profiles for temperature, pressure, velocities Vx and Vy for the flow in porous media which represents the a Diesel Particulate Filters (DPF) unit made of silicon carbide (SiC)[4,8]
At low velocities it can be noticed that EX80: 200/14 DPF unit type has the lowest pressure drop, it has a maximum values of transmission losses
Summary
The flow in the pure fluid region is usually described by the Navier-Stokes system of equations. The most popular models for the flow in the porous media are those suggested by Darcy and by Brinkman, the flow of several components and several phases through a porous medium is generally described by introducing macroscopic mass-balance equations under the form of generalized dispersion equations. Soil and sand are both examples of porous media and fluid flow in a porous medium can be considered as pouring a cup of water over soil and letting the water flow into the soil due to the gravitational forces. Fluid flow through a porous medium is often given by the phenomenological Darcy equation. The flow rate Q of the fluid through the medium is given by Darcy's equation, such that:
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: American Journal of Engineering and Applied Sciences
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
