Numerical analysis of the width of fracture process zone in concrete beams

Abstract

There are two ways of modelling cracking in concrete structures using a finite element method (FEM). In the first concept crack is considered as densely distributed throughout the finite area of element. The alternative approach assumes an isolated sharp interelement crack. The first concept of microcracked band is often used during numerical computations of concrete structures and a crack band model can be applied in design practice where relatively simple methods of calculations are preferred. In this model the width of microcracked zone, which is called the width of fracture process zone, is the additional parameter of tensile concrete.In this paper, the influence of the fracture process zone width on numerical calculations in case of bent concrete beams is analyzed. The results of numerical simulations are presented and compared with those obtained during the experiment. The crack band model proposed by Hillerborg [Cement and Concrete Research, 6 (1976) 773–782] has been used in numerical calculations and six different widths of fracture process zone have been modelled in the analyzed specimen. When comparing the obtained FEM-results their significant differences according to the width of fracture process zone have been observed. On the basis of the performed analysis it may be concluded that the width of fracture process zone taken in numerical simulations does have an influence on FEM-results.