Abstract
Dissipative mufflers are often used for the reduction of broadband noise transmitted in ducts. Many common calculation procedures for the transmission loss of such mufflers require conventional shapes like rectangular or circular cross-sectional areas. In an effort to analyze the effect of the cross-sectional area of dissipative mufflers on the resulting noise reduction, the transmission loss of axially uniform mufflers with polygonal cross-sectional areas was investigated using the finite element method. The mufflers are designed to have the same open area, and hence in a practical application would lead to a similar pressure drop. The results were compared to those obtained with the well known approximative method of Piening. Good agreement between simulation and estimation was found regarding basic trends at low frequencies, while notable differences were revealed regarding the maximum transmission loss.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: INTER-NOISE and NOISE-CON Congress and Conference Proceedings
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
