Abstract
In the present study, the thermal performance of a latent heat thermal energy storage device based on flat miniature heat pipe arrays with straight rectangular fins during the charging process is numerically investigated using porous media to reduce computational resources and time. Air is selected as the heat transfer fluid (HTF). The influence of a thermal storage unit (TSU) with one heat transfer component (HTC) on the melting rates of the phase change material (PCM) is simulated at different inlet temperatures and flow rates of HTF. The heat transfer between two HTCs that form a tandem is analyzed and compared, and the effect of different arrangements of the two HTCs on the charging process is then studied. Results indicate that the inlet temperature and the volume flow rate of the TSU influence the charging process. The average outlet temperature and charging power, which grow in a power function relationship with the volume flow rates, increase linearly with the inlet temperatures. The average charging power of the HTF through HTC-2 is reduced by approximately 63.71% compared with HTC-1 when the two HTCs form a tandem. The average charging power of the TSU with two HTCs connected in tandem is higher than that of the parallel TSU at the same inlet temperature and volume flow rate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
