Abstract
The shortcomings of gravity corers in sampling marine sediments have been observed extensively in various field tests. In order to optimize the coring, this article provides an alternative numerical way to model the gravity coring and analyze the sampling effect. Based on this analysis, a new hydraulic hammer corer is devised. A coupled Eulerian-Lagrangian method with capability of simulating the problem involving extreme deformation, penetration is used to simulate the coring process. The results show that the hydrostatic pressure and deviator stress increase and reach their peak when the pile tip is slightly above or at the level of the observation point and then drop rapidly when the pile tip slides below the observation point. In addition, the stress path indicates that the soil element sustains plastic compression before yielding and then expands until recovering to the original state. The obvious “under-sampling” phenomenon is also well-captured by the finite element model.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
