Abstract
Commercially available thermoplastic elastomers (TPEs) based on block copolymers of diisocyanates and polyols (i.e., TPUEs) were used to delay sharkskin and stick-slip instabilities in the extrusion of linear low density polyethylene (LLDPE). When TPUE is added in a small mass fraction to LLDPE, it deposits at the die surface during extrusion and may postpone the onset of sharkskin instability to a 12–20 times higher rate of extrusion. Substantial delay of sharkskin was also achieved under conditions without slip of molten PE inside the die coated by TPUEs. Efficiency to delay the instabilities depends on elasticity of TPUE at processing temperature. The TPUEs could be a cost-effective substitution of fluorinated polymers such as processing aid, lubricant and release agent in the processing of polyethylene by extrusion, blow molding, and injection molding. J. VINYL ADDIT. TECHNOL., 11:127–131, 2005. © 2005 Society of Plastics Engineers
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
