Novel Procedure for Determining the Finger Force in Flexion Depending on the Finger Position

Abstract

Abstract Introduction: The design and development of a novel dynamic hand orthosis that allows individual and progressive adaptation to the patient’s condition require knowledge about the maximum voluntary contraction forces of the fingers. The following work presents a test setup and procedure for determination of isometric finger contraction forces during flexion depending on various finger positions and finger tasks. Methods: The test setup places hand and fingers in certain positions (position 0: grasping of a plate; position 1-3: circular grasping of cylinders of three different diameters). The force measurement is carried out using pressure sensing: A capacitive force sensor is placed on each fingertip. To perform various finger tasks, the subjects are asked for isometric contraction of defined finger groups and single fingers against the boundary system. For proof of the concept, measurements are performed with six subjects and compared with reference values from the literature. Results: The separated finger force of each finger can be captured during the finger tasks in varying positions. Furthermore, the total finger force of all active fingers can be determined. It is shown that the total finger force during contraction of all fingers (IMRLtask; 78.4N ± 25.8N, d2) is higher than during contraction of the index finger (25.8N ± 3.4N, d2). Furthermore, the single finger force of the index finger is higher than the index finger activity in IMRL-task. The results also show a tendency for the finger contraction force to increase with increasing flexion. Further investigations may require improvements to the method. In this proof of concept, this potential is revealed and discussed. However, the functionality of the test setup and procedure can be demonstrated.