Novel method of ancient pottery analysis based on radioactive isotope ratios: a pilot study

Abstract

The proposed method has been applied to a multi-phased settlement complex and pottery manufacturing centre in Ostrowite in northern Poland. In this study the radioactive isotope ratios method has been applied to a set of ceramic pottery specimens from the same multi-layered archaeological site and probably produced from local raw material. The pilot radiometric research was based on: 24 Neolithic (5200–5000 BCE), 21 Early Iron Age (800–600 BCE), 4 Roman Period (100–400 CE), and 13 Middle Ages (1030–1320 CE) pottery fragments, and also 8 samples of local clay (glacial till) and 3 burned clay samples. The method shows the similarities within the ceramic material used to manufacture the pottery. The variations in the quantitative and qualitative compositions of the basic products (clay, silt, loam, sand, ash and organic admixtures) used in the preparation of the ceramic paste change the isotopic composition and activity ratios. Pottery from each ceramic manufacturing centre, based on the specific composition of the raw materials, have characteristic isotope ratios. Radioactive isotope ratios as fingerprints of ancient ceramic manufacturing centres have not yet been applied as an archaeometric method. In this study two isotope ratios have been selected and applied: 40K/228Ac and 226Ra/208Tl. All analysis have been done using gamma spectrometry system, with quality and quantity analysis of the spectrums. Low-background passive shield was used for obtain improvement of results quality. The pilot study confirms the grouping of isotope ratio results for each sample type, even in terms of similarities with the base clay material collected in this region.