Abstract
We report a novel fiber taper facility that allows the fabrication of fiber tapers between a few centimeters and tens of meters in length and that can be used for standard and microstructured optical fibers (MOFs). Efficient reduction of error in diameter variation is achieved using the velocity control feedback loop. The experimental results of the tapering of both the step index fiber and the MOF are presented. The observed outer diameter tracking error over the taper length was within 1%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
