Novel, low‐cost jute‐polyester composites. Part 1: Processing, mechanical properties, and SEM analysis

Abstract

AbstractThe development of high performance composites from a cheap natural fiber, jute, as reinforcement is particularly significant from an economic point of view. In this work, jute fiber‐unsaturated polyester(GP) composites having appreciable mechanical properties were prepared by using solution impregnation and hot curing methods. Both unbleached (control) and bleached jute slivers with various percentages of fiber loadings were used to prepare the composites and were named JPH (C) i.e., Jute Polyester Hot Curing (control), and JPH (B) i.e., Jute Polyester Hot Curing (bleached), respectively. Mechanical properties such as tensile and flexural strain, toughness, and moduli of both the grades have been compared. Composites having 60 wt% of jute fiber yielded the best results. JPH (B) showed much better flexural properties than JPH (C), although the tensile properties of the latter were better. The inter‐laminar shear strength (ILSS) of the JPH (B) was found to be higher than JPH (C). The nature of fiber‐resin bonding was studied from scanning electron micrographs of the specimens subjected to tensile and flexural fracture. Dynamic mechanical properties were found to be very high, superior even to those of glass fiber reinforced composites. The flexural storage modulus was found to be 12.3 GPa at 30°C and to decrease slowly with temperature. The major finding in this work is the attainment of high mechanical properties of composite specimens with 60 wt %fiber loading. On a weight and cost basis, bleached jute fibres were found to be better reinforcements than other fibers with usual surface modification by coating or grafting processes.