Novel insight into the hydrogen absorption mechanism at the Pd(110) surface

Abstract

The microscopic mechanism of low-temperature (80 K < T < 160 K) hydrogen (H) ingress into the H2 (<2.66 × 10(-3) Pa) exposed Pd(110) surface is explored by H depth profiling with (15)N nuclear reaction analysis (NRA) and thermal desorption spectroscopy (TDS) with isotope (H, D) labeled surface hydrogen. NRA and TDS reveal two types of absorbed hydrogen states of distinctly different depth distributions. Between 80 K and ∼145 K a near-surface hydride phase evolving as the TDS α1 feature at 160 K forms, which initially extends only several nanometers into depth. On the other hand, a bulk-absorbed hydrogen state develops between 80 K and ∼160 K which gives rise to a characteristic α3 TDS feature above 190 K. These two absorbed states are populated at spatially separated surface entrance channels. The near-surface hydride is populated through rapid penetration at minority sites (presumably defects) while the bulk-absorbed state forms at regular terraces with much lower probability per site. In both cases, absorption of gas phase hydrogen transfers pre-adsorbed hydrogen atoms below the surface and replaces them at the chemisorption sites by post-dosed hydrogen in a process that requires much less activation energy (<100 meV) than monatomic diffusion of chemisorbed H atoms into subsurface sites. This small energy barrier suggests that the rate-determining step of the absorption process is either H2 dissociation on the H-saturated Pd surface or a concerted penetration mechanism, where excess H atoms weakly bound to energetically less favorable adsorption sites stabilize themselves in the chemisorption wells while pre-chemisorbed H atoms simultaneously transit into the subsurface. The peculiarity of absorption at regular Pd(110) terraces in comparison to Pd(111) and Pd(100) is discussed.