Novel heat flux controlled surface cooling for hypersonic flight

Abstract

This paper presents a new method in theory and experiment to adjust the transpiration cooling based on the actual measured heat flux. This is particularly useful in extreme heating environments, e.g. atmospheric entry flight or combustion chamber applications. In such environments, usually cooling is set constant based on the vehicle design, yet a mass efficient and performant cooling is sought after. We present a method with real-time surface heat flux determination of the transpiration cooled wall and an automatic adjustment of the cooling. The heat flux is determined based on a system identification process. The heat flux measurement itself is derived non-intrusively from the measurement of pressure inside the plenum, i.e. the region between mass flow controller and porous wall. The particular advantage of this system is that the heat shield material is not weakened by any sensor system and its performance is optimized with respect to cooling needed at a certain heating level. Another new feature of the pressure heat flux transformation is the attenuation of a destabilizing positive feedback loop, where the transpiration cooling controller’s output (i.e. mass flow rate) strongly influences its input (i.e. plenum pressure). We describe the identification of the model parameters for the heat flux determination, which are found and verified by a calibration approach. The controlled cooling was demonstrated in a hot air plasma flow with a reference heat flux of up to 1.4 MW/m^2. The results show the performance and verify the applicability in a real flight environment.